Connectors - Page 5

Power extension cable for fan with 3 pins- 45 cm

Réf. : 146871

This adapter cable is ideal for full-size PC cases.

Main features :

- Input connector : 3-pin female
- Output connector: 3-pin male
- Cable length: 45 cm

Motherboard Adapter- 2 x USB2.0 internal ports

Réf. : 307822

This adapter adds 2 x USB2.0 Type A female connectors to your PC case.
Ideal for the following devices installed in a front space:

- USB duplicator
- Memory card reader
- USB wireless adapter; etc...

Product features:

- Input connector: 1 x USB2.0 9-pin DIP
- Output connectors: 2 x USB2.0 Type A female
- Supported data transfer rates: 1.5/ 12/ 480 Mbit/s
- Without cable

Molex to SATA angled power adapter cable- 15 cm

Réf. : 147553

The downward-angled, 90-degree SATA power connector allows this cable to be used where normal straight connector cables cannot, accommodating tighter space limitations while minimizing the strain on the cable.
This adapter cable is ideal to connect a SATA HDD to a power supply with no/ not enough SATA connector(s).

Main features :

- Input connector: 1 x 4-pin Molex male
- Output connector: 1 x SATA downward-angled female
- Cable length: 15 cm

24-pin to 20-pin power cable adapter for motherboard-10 cm

Réf. : 314071

With this adapter cable, you can connect a 24-pin ATX power supply to a motherboard equipped only with 20-pin ATX connectors.
The wiring drawing complies with EPS/12V specifications on the 24-pin side and to the ATX2.x specifications on the 20-pin side.

Main features:

- Input connector: 1 x 24-pin ATX
- Output connector: 1 x 20-pin ATX
- Cable length: 10 cm

Blind Slot Bracket- Bag of 10pcs

Réf. : 740351

Blind slot brackets by 10 pieces.

USB3.0 Slot Bracket- 2 Ports

Réf. : 146697

This slot cable is to be connected to a USB slot of your motherboard. It adds 2 external USB3.0 ports. It has two 10-pin DIP and 2 x USB3.0 type A female connectors, linked by a 25-cm cord.

Product features:

- Internal connector: 10-pin DIP (2 x 5)
- Bracket connectors: USB3.0 female type A
- Cable length: 25 cm.

M.2 NGFF SATA to 2.5" SATA Adapter

Réf. : 307607

6Gbps SATA III H/W RAID Controller

Product benefits:

- Rapid SSD to SATA conversion
- Natural air flow
- Same size than a 2.5'' SSD
- Can be easily adapted into a PC, laptop
- Transparent for the system
- Hardware-based RAID 1/ SPAN and PM

Main features:

- Converts 2x M.2 NGFF SATA based SSD to a standard 2.5'' 7mm SATA drive
- Supports SATA I, SATA II, SATA III Host port
- Supports 6Gbps, 3Gbps SATA-based M.2 NGFF 80/60/42/30 mm SSD
- M.2 NGFF type 2280-D5-B connector on board
- Movable M.2 NGFF stand-off and multiple plated-holes supports type 2280, 2260, 2242 and 2230 SSD
- Supports dual-sided SSD module 1.5mm component height on the top and bottom side
- Supports H/W RAID 1, SPAN (Big Drive) and PM (2Drives) Modes
- Does not support PM (2 Drives) Mode if SATA I or no Port Multiplier compatible
- SATA Host connection
- 22-pin SATA (Signals and Power) male connector on board
- 2x M.2 SSD ACT LED
- Transparent to the operating system, no driver required on Windows, Mac and Linux
- Provides Windows and Mac GUI to configure RAID modes and monitor RAID status
- Includes 7mm height 2.5'' drive metal frame with 8 mounting holes and 4 HDD screws
- Compatible with 2.5'' SATA drive dimension : 100.45mm x 69.85mm x 7mm

PCI Express 6-pin Y power cable- 15 cm

Réf. : 146694

Split a PCI-Express 6-pin power connector into 2 x PCI-e connectors to supply the power to a
graphic card that requires 2 x power supplies or two graphic cards.
An indispensable low-cost solution for the power supplies that are not equipped with a PCI-Express power supply.

Product features:

- Input connector: 1 x PCI-Express 6-pin connector
- Output connectors: 2 x PCI-Express 6-pin connectors
- Cable length: 15 cm.